New Holland W130D Service Manual page 76

29. Install the P-clamp and the cable ties to connect the
end of the jumper harness (near the supply module)
to the DOC support.
30. Secure the NOx sensor wire harness with the clamps
(2) to the catalyst mounting support bracket using the
hexagonal bolts (1).
Secure the wire harness with the wire ties where ap-
propriate.
31. Attach wire harness support clamp.
32. Connect the grid heater cable (1)
NOTE: hold the rear nut with a second wrench to prevent
grid heater damage.
Engine - Engine and crankcase
51428248_EN 18/12/2017
10.1 [10.001] / 39
30
LEIL15WHL0034AB
31
LEIL13WHL0223AB
32
LEIL16WHL0490AB
33
LEIL13WHL0164AB