PREVOST XL Series Manual page 48

Switching off heater. Press
Operating display
automatically continues to operate to cool the
heater down.
Heating without preselection when ignition is
''on.''
Switch on the heater. Press
The operating display
heating stays in operation until the ignition is
switched off.
If the ignition is switched off, a residual
heating period of 15 minutes remains. This
can be extended to max. 120 minutes by
pressing the > key or reduced by pressing
the < key.
Heating operation preselection.
Setting and activating the memory for
heating operation and the alarm clock.
P
Press several times until the required
memory No. (1, 2, 3) appears flashing on the
display. Press < or > key briefly, and release.
Then set the preselected time for the heater
using the < or > key.
As soon as this stops flashing and the
weekday flashes, set the weekday.
The preselected time and weekday are
stored as soon
disappears or changes over to clock time.
The memory number indicates what memory
is activated. Only one memory can be
activated.
key briefly.
disappears. The blower
key briefly.
appears. The
as the time display
WEBASTO (45 000 or 80 000 BTU)
OPERATION WITH DIGITAL TIMER
FIGURE 65
1. To set the clock
If the time display e.g. 18:33 is wrong, or if it
flashes 8:88, press button
time press either
(forwards). The longer you hold the button down,
the quicker the display changes. The last few
minutes are set accurately by quick pushes.
Adjust to get exact time, e.g. 23:59. The display
fades after 20 secs.
2. Do you want to know the time?
Just press 4 at any time. The display appears
again.
2 - 47
CONTROLS/INSTRUMENTS
1 and at the same
2 (backwards) or
18046
3