PREVOST XL Series Manual page 34

Your vehicle is equipped with two (2) exterior
mirrors. These mirrors have an electric heating
system which serves to minimize ice and
condensation in extreme weather conditions.
Integral thermostats are installed in both mirrors
to avoid continual heating. Use the appropriate
switch on the L.H. side control panel (item #6 on
page 2-4) to activate the defroster system on both
mirrors simultaneously.
The standard mirrors can easily be adjusted by
using the remote control knobs located on L.H.
side control panel (items #15 & 16 on page 2-4).
On the optional two-glass mirror, only the flat
mirror can be remotely adjusted. The convex
mirror must be adjusted manually.
The exterior mirrors can be manually adjusted as
per the following method:
• To obtain desired vehicle width, adjust the
mirror arm angle by loosening the
adjusting "Allen" screw located at body
end of mirror arm. Adjust mirror arm to
desired position, then tighten adjusting
screw.
CAUTION:
Do not overtighten.
Mirror arm
Adjusting bolt
FIGURE 40: OPTIONAL MIRROR
Convex mirror
Flat mirror
''Allen'' screw
18036A
2 - 33
CONTROLS/INSTRUMENTS
• Mirror head can be rotated and/or tilted by
loosening the adjusting "Allen" screw
located at the base of mirror head. Adjust
to desired position, then tighten adjusting
screw.
CAUTION:
Do not overtighten. Do not install a
convex mirror on the heated mirror glass. This
prevents even distribution of heat in the heated
mirror and could cause the glass to break.
WARNING
: Objects in convex mirror are closer
than they appear.
Mirrors should not extend beyond body of coach
any more than necessary.
NOTE:
It is important for safe driving that you
have good rear vision on each side of the vehicle;
therefore, adjust mirrors before driving and
immediately after adjusting your seat.