Tightening Nozzle Nut - WAGNER TOPFINISH GM 1030P Operating Manual

VERSION 02/2019

10.8 TIGHTENING NOZZLE NUT

1. Flush and clean the spray gun in accordance with Chapter 8.1.3.
2. Relieve the pressure of the product pressure generator and of the spray gun in
accordance with Chapter 7.4.
3. Remove air cap nut (A) and air cap (B).
4. Check nozzle nut (C) for correct seating and, if necessary, tighten with a size 13 wrench.
Coat inside with Molykote® DX (E).
Note: Tighten only with the trigger pulled!
5. Fit air cap (B) back onto nozzle nut (C) and tighten air cap (A) by hand.
E
12 Nm; 8.85 lbft
C
B
A
ORDER NUMBER DOC 2397374
B_07061
TOPFINISH GM 1030P
40