Adjusting The Spray Pattern - WAGNER TOPFINISH GM 1030P Operating Manual

VERSION 02/2019
7.3

ADJUSTING THE SPRAY PATTERN

Desired spraying result
B_06976
Rectifying defects in a spray pattern
Spray pattern
B_06977
B_06978
B_06979
B_06980
B_06981
Note: B_06982
The flow rate can be changed by:
– Changing the product pressure or limiting the needle stroke.
– Use of another nozzle (see Chapter 10.9,
ORDER NUMBER DOC 2397374
Deviation
Spray pattern is too wide
in the middle
Spray pattern is too wide
on the ends
Spray pattern has very
coarse droplet distribution
Material application is very
thin in the middle of the
spray pattern
The spray pattern is
divided in the middle
Spray patter is too round
13.2
Required setting
– Set a wider spray shape
– Set a rounder spray shape
– Increase the atomizing air pressure
– Reduce the atomizing air pressure
– Increase the nozzle diameter
– Reduce the atomizing air pressure
– Increase the product pressure
– Reduce product pressure
– Increase the atomizing air pressure
and 13.3).
TOPFINISH GM 1030P
24