Advertisement
714-630-7144
After your trailer has been properly attached to the tow vehicle, as previously
described, you must fold out the back half of the trailer to load motorcycle(s).
Make sure the area you are working in is level and both the surface area and
trailer are dry to avoid slipping.
Each trailer is equipped with one or multiple loading ramps. On standard
Single, Dual and Combo push-up operation models you will find the ramp
secured to the underside of the rear section. On Ride-Up models you will find it
attached to the underside of the rear section and/or the deck of the trailer. On
the ATV/Utility Trailer/Smart Car trailers you'll find two ramps secured next to
the front guardrails. Refer to the separate Go! Series model specific
instructions for ramp location(s) and use (if applicable).
Make sure the ramp is properly secured to the trailer prior to loading the
motorcycle(s). Never attempt to ride your motorcycle(s) up or down the loading
ramp unless you have a Ride-Up specific trailer.
Attach ramp to rear of trailer. Look directly at the rear section of your trailer,
you will see open slots that line up with the ramp hook(s). These slots are also
marked with red warning decals. The ramp hook(s) must go into these slots
only.
•
Hold ramp at approximately 45 degree angle (ramp hook(s) down, rear
of ramp is up at approximately 45 degrees)
•
Line up ramp hook with slots on the rear section of the trailer
Proper Ramp Attachment and
Loading/Unloading
- 12 -
www.KendonUSA.com
Advertisement
