Related Manuals for Kendon Stand-Up SINGLE RIDE-UP Go Series
Summary of Contents for Kendon Stand-Up SINGLE RIDE-UP Go Series
- Page 1 ™ GO! SERIES ™ SINGLE RIDE-UP STAND-UP TRAILER INSTRUCTIONS KENDON INDUSTRIES, LLC 2990 E. Miraloma Ave. Anaheim, CA 92806 USA Tel 714-630-7144 • Fax 714-630-7132 www.KendonUSA.com Rev. 112619...
- Page 3 714-630-7144 www.KendonUSA.com WARNING: Serious injury, death and/or property damage could result through improper use of this product, including crushing or severing type injuries. WARNING: Thoroughly read and understand all instructions and owner’s manual(s) before using the trailer. WARNING: For Adult Use Only. Keep children away from trailer at all times.
- Page 4 WARNING: Ramps must be properly secured to trailer prior to towing. Trailer owner is responsible for complying with all the recommended procedures in this instruction manual. Use at your own risk. Kendon is not responsible for injury, liability, property damage and/or any consequential damage(s) caused by the misuse of this product.
-
Page 5: Loading Ramps
Ensure the wheel chock on the rail is in the open position (pg. 10). LOADING RAMPS How to use the ramps on your Kendon Go! Series Ride-Up Single Trailer: Insert the ramp hook as shown below between the tubular rails on the rear folding section of the trailer. - Page 6 Go! Single Ride-Up trailer instructions and familiarize yourself thoroughly with the parts on your new Kendon Go! Single Ride-Up Trailer. In addition to these instructions, be sure to read and follow the Go! Series™ Trailer Owner’s Manual for all Kendon Go! Series Stand-Up™...
- Page 7 Loading and Unloading Process Loading and unloading a motorcycle onto any vehicle, either a trailer or a pick- up truck requires certain skills and techniques. Kendon recommends using two spotters while practicing the loading and unloading technique with your bike with your abilities.
- Page 8 714-630-7144 www.KendonUSA.com Usage Instructions for Kendon Go! Series Ride-Up Single Trailer Thoroughly read and understand these instructions and the separate attached Owner’s Manual for Kendon Go! Series™ Stand-Up™ Trailers. Attach the Trailer to Tow Vehicle making sure the coupler completely engages the ball and that the coupler latch is locked down.
- Page 9 714-630-7144 www.KendonUSA.com Left (Driver’s Side), Center and Right (Passenger’s Side) Ramp Configuration Diagram - 7 -...
- Page 10 714-630-7144 www.KendonUSA.com There are two (2) Ramp Pins and they are both the same. One (1) ramp pin unites the ramps at the top and one (1) unites the ramps at the bottom creating one connected loading platform. Hook each ramp to the rear folding section of the trailer going in the following order: Left, Center and Right ramp.
- Page 11 714-630-7144 www.KendonUSA.com Properly Installed Top Ramp Pin Slide the second ramp pin through the ramps following the same process. Properly Installed Bottom Ramp Pin NEVER USE RAMPS WITHOUT BOTH RAMP PINS FULLY ENGAGED AS INSTRUCTED AS THIS WILL CAUSE THE RAMP PLATFORM TO BE UNSTABLE.
- Page 12 (4) places as outlined in the Go! Series Trailer Owner’s Manual. KENDON USES A FOUR (4) POINT TIE DOWN SYSTEM. IT IS NOT SAFE TO TOW YOUR MOTORCYCLE WITHOUT TYING IT DOWN OR BY ONLY USING THE FRONT OR REAR TIE DOWNS.
- Page 13 714-630-7144 www.KendonUSA.com Proper Ramp Storage Before the ramp pins can be slid out, you will need to depress the lock button at one end of each pin. Once the lock button is pressed, you can slide the ramp pins out. Repeat this procedure for both top and bottom ramp pins. Detach the ramps from the rear section of the trailer.
- Page 14 714-630-7144 www.KendonUSA.com One (1) ramp pin can be stored on the side of either one of the side ramps. Make sure to slide the ramp pins all the way through so that the lock button is popped out on the opposite end of insertion point. Position the open diamond shape of the expanded metal on the ramp with the attachment points on the trailer.
- Page 15 714-630-7144 www.KendonUSA.com Unloading Attach ramps as instructed on pg. 6. Remove all four (4) tie-downs from vehicle. The motorcycle will not easily roll back to unload due to the design and function of the front wheel chock. Tips and Technique When the trailer is loaded, the front wheel chock captures the front wheel of the motorcycle.
- Page 16 Please refer to the Kendon Go! Series Trailer Owner’s Manual for additional care and maintenance instructions for your Stand-Up™ Trailer. Thank you again for purchasing our Kendon Product. If you have any questions on the proper use of this trailer please contact Kendon directly at 714-630-7144 or info@KendonUSA.com.
- Page 17 714-630-7144 www.KendonUSA.com NOTES - 15 -...
- Page 18 714-630-7144 www.KendonUSA.com WARNING: Serious injury, death and/or property damage could result through improper use of this product, including crushing or severing type injuries. WARNING: Thoroughly read and understand all instructions and owner’s manual(s) before using the trailer. WARNING: For Adult Use Only. Keep children away from trailer at all times.
- Page 19 WARNING: Ramps must be properly secured to trailer prior to towing. Trailer owner is responsible for complying with all the recommended procedures in this instruction manual. Use at your own risk. Kendon is not responsible for injury, liability, property damage and/or any consequential damage(s) caused by the misuse of this product.
- Page 20 Visit us at www.KendonUSA.com for product updates, new products, and support. NO PART OF THESE INSTRUCTIONS MAY BE COPIED AND/OR REPRODUCED WITHOUT THE WRITTEN PERMISSION OF KENDON INDUSTRIES, LLC ALL PART NUMBERS, DIMENSIONS AND SPECIFICATIONS IN THESE INSTRUCTIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.