Pfaff EcoDrive P40 ED Instruction Manual page 7

Programmed stop (only in programmed sewing)
If this key is pressed the corresponding function is switched on or off. When the function
is switched on, in programmed sewing the machine stops automatically at the end of the
seam section.
Photocell
In manual sewing the number of compensating stitches from the point where the
photocell is light to the end of the seam can be set under parameter 111, and in
programmed sewing directly.
Stitch counting (only in programmed sewing)
If this key is pressed the corresponding function is switched on or off. When the function
is switched on, in programmed sewing the machines switches to the next sewing
section after the number of stitches entered have been sewn.
TE/Speed
If this key is pressed once while the machine is in the sewing mode, the input menu for
the maximum speed is selected. If no input is made within 5 seconds, the sewing mode
is selected again.
If this key is pressed twice (within 5 seconds) while the machine is in the sewing mode,
the machine switches to parameter input.
If this key is pressed once while the machine is in the parameter input mode, the altered
values are stored and the sewing mode is selected.
Scrolling
If this key is pressed, the machine scrolls between the sub-menus in the program.
PM
If this key is pressed the programmed sewing function is switched on or off. When the
function is switched on, the letters "PM" appear on the display of the control panel. The
parameters related to the program are shown in the alpha-numerical part of the display.
F1
Press this key to sew a single stitch (only with control unit P70 ED)
F2
Piece counter (only with control unit P70 ED)
When this key is pressed the first time, the piece counter is displayed for 3 sec.
If pressed again during the display period, the piece counter is reset.
The piece counter only counts when the "thread trimming" function is
activated.
F3
No function
F4
No function
Controls
3