Operating Elements Of The S2 Control Panel; Screen Displays; Function Keys - Pfaff EcoDrive P40 ED Instruction Manual

1

Operating elements of the S2 control panel

The control panel is used to create and alter seam programs, enter parameter values and
read error messages and service settings.
1
6
The control panel consists of display 1 and the function keys described below. Display 1
consists of a two-row, alpha-numerical display with 16 symbols per row. The special
symbols 3 and texts 4 show the respective status of the function keys and the operating
modes of the machine.
During the power-on phase the control panel automatically switches on all LCD segments
and the horn. The number of the version of the installed software then appears on the
display, until the higher-ranking control unit sends commands to the control panel.
1

Screen displays

.01
Activated functions are displayed with a triangular marking 2 below or next to the
respective function key.
In the sewing mode all relevant sewing data is displayed and these can be changed
directly, depending on the status of the machine, see also Chapter 2 Sewing.
During the parameter input the selected parameter number with the corresponding value
is displayed, see Chapter 2.06 Parameter settings.
1

Function keys

.02
The function keys described below are used basically to switch machine functions on and
off.
If a corresponding value has to be set for the activated function, this is carried out with the
corresponding +/- key. For example, by pressing and holding the +/- key 5, the numerical
value 6 shown above the key is changed slowly to begin with. If the +/- key 5 is held down
longer, the numerical value 6 is changed more quickly.
2 4
PM
1 1
5 3
10
Controls
1