Electrical Connection - EAS Electric EMV56RC Instruction Manual

Electrical connection

Those ovens equipped with a three-pole power supply cable are designed to operate with
an alternating current. The wire for earthing the appliance is yellow-green in color.
Fitting on a power supply cable:
Using a screwdriver, prize the bolt on the side tabs of

the terminal board cover and pull open the cover;
Remove the wire clamp screw and the three contact

screws L-N and
Fasten the wires beneath the screw heads using the

following color scheme :Blue (N) Brown (L) Yellow-
Green ( )
 Fasten the supply cable in place with the clamp and
close the cover of the terminal board .
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When
connecting the cable directly to the mains, install an omni polar circuit breaker with a
minimum contact opening of 3 mm between the appliance and the mains. The omni
polar circuit breaker should be sized according to the load and should comply with
current regulations (the earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more
than 50ºC with respect to the room temperature, anywhere along its length, or
protected by insulation sleeping having an appropriate rating.
Before making the connection, check that:
The electrical safety of this appliance can only be guaranteed if the cooker is

correctly and efficiently earthed, in compliance with regulations on electrical
safety. Always ensure that the earthing is efficient; if you have any doubts call in
a qualified technician to check the system. EAS ELECTRIC Smart Technology S.L.
declines all responsibility for damage resulting from a system which has not been
earthed.
Before plugging the appliance into the mains, check that the specifications

indicated on the date plate (on the appliance and /or packaging) correspond to those
of the electrical mains system of your home.
Check that the electrical capacity of the system and sockets will support the

maximum power of the appliance, as indicated on the data plate. If you have any
doubts, call in a qualified technician.
 If the socket and appliance plug are not compatible, have the socket replaced with a
suitable model by a qualified technician. The latter, in particular, will also have to
ensure that the cross section of the socket cables are suitable for the power
absorbed by the appliance. The use of adapters, multiple sockets and/or extensions,
is not recommended. If their use cannot be avoided, remember to use only single or
multiple adapters and extensions which comply with current safety regulations. In
these cases, never exceed the maximum current capacity indicated on the single
adapter or extension and the maximum power indicated on the multiple adapter.
The plug and socket must be easily accessible.
.
12 V.1