Page 1
The images may vary depending on the product and software version. Information contained in this document is subject to change without notice. EverFocus Taiwan: 2F., No.12, Ln. 270, Sec. 3, Beishen Rd., Shenkeng Dist., New Taipei City 222, Taiwan TEL: +886 2 2662 2338 FAX: +886 2 2662 3632 www.everfocus.com.tw...
Page 2
1. Physical Description EZN1240-SG / EZN1540-SG / EZN2540-SG No. Item Name Descriptions Use the supplied Hexagon Wrench to loosen the Reset Button screws to access the Reset Button and Micro SD / Micro SD Card Slot slot. Sunshield Protect the camera from the direct fun rays. Use the supplied Hexagon Wrench to loosen the Tilt Screw Tilt Screws.
Page 3
2. Contact the shipper if any items appear to have been damaged in the shipping process. Optional Accessory You can go to the product page on EverFocus’ website to check the related optional accessories. www.everfocus.com.tw...
Page 4
2. Cables The cables provide connections for network and power. LAN / PoE Cable Power Cable (12VDC) Reset Button The Reset Button can be used to restore the camera to factory default. When the camera is powered up, press the Reset Button about 10 seconds to reboot the camera.
Page 5
3. Installation 3.1 EZN Series 1. Drill three holes on the surface according to the screw positions on the Camera Base. Push the supplied 3 Screw Anchors into the holes. Drill another hole in the middle within the 3 screw holes if you wish to run the wires into the surface.
Page 6
4. Accessing the Camera You can look up the IP address of the IP camera using the IP Utility (IPU) program from EverFocus website (key word search: "IP Utility"). The default network is DHCP. However, if there is no dynamic IP address assigned to the device, its IP will switch to 192.168.0.10.