Component List; Technical Data; Working Hints For Your Tool - KRESS KU310 Safety And Operating Manual

COMPONENT LIST

1. CHUCK
2. AUXILIARY HANDLE
3. HAMMER DRILL /DRILL SELECTOR DIAL
4. LOCK-ON BUTTON
5. ON/OFF SWITCH
FORWARD AND REVERSE ROTATION
6.
CONTROL
Not all the accessories illustrated or described
are included in standard delivery.

TECHNICAL DATA

Voltage
Rated input power
Rated no load speed
Impact rate
Chuck capacity
Steel
Max drilling
Concrete
capacity
Wood
Machine weight
Protection class
ACCESSORIES
Chuck key
Auxiliary Handle
Depth Gauge
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruc-
tion book carefully.
Impact drill
220-230V~50Hz
650W
0~3000r/min
0-45000/min
13mm
13mm
13mm
25mm
1.69kg
/II
1
1
1
INTENDED USE
The machine is intended for hammer drilling in brick,
concrete and stone. It is also suitable for drilling without
impact in wood, metal and plastic.
ASSEMBLY AND OPERATION
Action
Clamp and release the auxiliary
handle
WARNING! To avoid
accidents, please be sure
to check and tighten the handle
before use.
Chuck Adjustment
Connect the power
On/off switch and lock-on button
Forward and reverse rotation
control
NOTE: Do not move the
forward and reverse rotation
control when the drill is
working or the switch is
locked to avoid damage to
the drill.
Hammer drill /drill selector dial
WORKING HINTS FOR
YOUR TOOL
1. For drilling of stones and concrete
Set the hammer/drill control button to the "hammering"
position. Tungsten carbide drill bits are used for rapid
drilling of stones and concrete.
2. For drilling of steel
Set the hammer/drill control button to the "drilling"
position. High-speed steel drill bits are used for drilling
of steel in a slow manner.
3. For locating holes
When drilling large holes in rigid materials such as steel,
it is recommended to drill a small locating hole before
using a large drill bit.
4. For drilling of tiles
Set the hammer/drill button to the "drilling" position.
After penetrating the porcelain, set to the "hammering"
position
5. Cooling motor
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool
the motor.
FIGURE
See Fig. A1,A2
See Fig. B1,B2
See Fig. C
See Fig. D
See Fig. E
See Fig. F
KU310
9