Table of Contents
Advertisement
COMPONENT LIST
1.
KEY STORAGE TAB
2.
ON/OFF SWITCH
3.
LOCK ON BUTTON
4.
FORWARD/REVERSE ROTATION CONTROL
5.
KEYLESS CHUCK
Not all the accessories illustrated or described are
included in standard delivery.
TECHNICAL DATA
Voltage
Power input
No load speed
Chuck capacity
Wood
Max. drilling
Steel
capacity
Aluminum
6
Protection class
Machine weight
We recommend that you purchase your accessories
listed in the above list from the same store that sold you
the tool. Refer to the accessory packaging for further
details. Store personnel can assist you and offer advice.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INSERTING A TOOL INTO CHUCK
KEYLESS CHUCK
Grip rear collar of keyless chuck and rotate front collar
until chuck is open sufficient for tool to be inserted.
Insert the tool into the chuck. Grip rear collar and
manually rotate front collar until tight. The locking
mechanism is automatically released when the front
collar is rotate in the opposite direction in order to
remove the tool. (See Fig. A)
Hand drill
220-230V~50Hz
500W
0~2800r/min
10mm keyless chuck
20mm
10mm
10mm
/ll
1.2kg
OPERATION
1. ON/OFF SWITCH (SEE FIG. B)
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON (SEE FIG. B)
Switch on: Depress on/off switch then lock on button,
your switch is now locked on for continuous use.
Switch off: To switch off your tool just depress and
release the on/off switch.
3. FORWARD AND REVERSE ROTATION
CONTROL (SEE FIG. C)
For drilling use forward rotation marked "
moved to the left).
Only use reverse rotation marked "
moved to the right) to bound drill bits.
Never change the direction of rotation when the tool is
rotating, wait until it has stopped.
4. VARIABLE SPEED CONTROL
Depress on/off switch to increase or decrease the speed
according to the material and accessory to be used
(also possible during no load operation). Higher speed
will produce a lower torque while a lower speed will
produce a higher torque.
WORKING HINTS FOR
YOUR DRILL
If your power tool becomes too hot set the speed to
maximum and run no load for 2-3 minutes to cool the
motor.
When drilling in metal, only use HSS drill bits in good
condition.
Always use a magnetic bit holder when using short
screwdriver bits.
Where possible use a pilot hole before drilling a large
diameter hole in the metal material.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool.
1. Wipe clean with a dry cloth after use. Note: Never use
water or chemical cleaners to clean your power tool.
2. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
Note: Do not use it in a dusty environment.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
" (lever is
" (lever is
KU110K
Advertisement
Table of Contents
