Table of Contents
Advertisement
Additional Information
Troubleshooting
1
Make sure the power cord and
speaker cords are correctly and firmly
connected.
2
Find your problem in the checklist
below, and take the indicated
corrective action.
If the issue persists, contact your
nearest Sony dealer.
If the STANDBY indicator flashes
Immediately unplug the power cord,
and check the following items.
If your system has a voltage selector,
is the voltage selector set to the
correct voltage?
Are you using only the supplied
speakers?
Is anything blocking the ventilation
holes on the top or back of the
system?
Is the connector of WM-PORT
short-circuited?
After the STANDBY indicator stops
flashing, reconnect the power cord,
and turn on the system. If the issue
persists, contact your nearest Sony
dealer.
General
The system does not turn on.
Is the power cord plugged in?
There is no sound.
Are the + and speaker cords short-
circuited?
Are you using only the supplied
speakers?
Is anything blocking the ventilation
holes on the top or back of the system?
The specified station may have
temporarily stopped broadcast.
The STANDBY indicator remains lit
after unplugging the power cord.
The STANDBY indicator may not turn
off immediately after unplugging the
power cord. This is not a malfunction.
The indicator will turn off after about
40 seconds.
Sound comes from one channel,
or the left and right volumes are
unbalanced.
Place the speakers as symmetrically as
possible.
Connect only the supplied speakers.
Severe hum or noise.
Move the system away from sources of
noise.
Connect the system to a different wall
outlet.
Install a noise filter (available
separately) to the power cord.
The remote does not function.
Remove any obstacles between the
remote and the remote sensor on the
unit, and position the unit away from
fluorescent lights.
Continued
GB
Advertisement
Table of Contents
