Troubleshooting; Specifications - Sony CDP-XE900E Operating Instructions Manual

Hide thumbs Also See for CDP-XE900E:
Table of Contents

Advertisement

Available languages

Available languages

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the output level with LINE OUT LEVEL
+/– on the remote.
The CD does not play.
/There's no CD inside the player ("no dISC"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 14).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
The recording level has changed.
/The recording level changes if you press the
LINE OUT LEVEL +/– buttons on the remote
during recording.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
The disc tray opens and closes automatically when you
turn on the player.
/The player does this if you pushed the disc tray
in while the power was off the last time you
used the player.
/The player does this if the disc tray slipped out
of position due to shock or vibration during
transport.
Additional Information
Additional Information

Specifications

Compact disc player
Laser
Semiconductor laser ( = 780 nm)
Emission duration: continuous
Laser output
Max 44.6 W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Dynamic range
More than 99 dB
Harmonic distortion
Less than 0.0025%
Outputs
Jack
Maximum
type
output
level
LINE OUT
Phono
2 V
jacks
(at 50 kilohms)
DIGITAL
Optical
–18 dBm
OUT
output
(OPTICAL)
connector
General
Power requirements
220 V AC, 50/60 Hz
Power consumption
14 W
Dimensions (approx.)
430 107 295 mm
(w/h/d)
(17
4 1/4 11 5/8 in.) incl. projecting
parts
Mass (approx.)
5.2 kg (11 lbs 7 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 50 kilohms
Wave length: 660 nm
15
EN

Advertisement

Table of Contents
loading

Table of Contents