Recording From Cds; Recording Your Own Programme - Sony CDP-XE900E Operating Instructions Manual

The programme remains even after the Programme
Play ends
When you press (, you can play the same programme
again.
You can check the total playing time while
programming using the remote (Programme Edit)
To select a track, press = or + and check the total
playing time. Then press PROGRAM to confirm your
selection.
Notes
• The total playing time doesn't appear in the display when it
exceeds 100 minutes.
• "FULL" appears in the display when you try to add a track
to a programme which already contains 24 tracks.
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK.
Each time you press this button, the display shows the
track number in the programmed order. After the last
track in the programme, the display shows "End" and
returns to the original display. If you check the order
after you start playing, the display shows only the
remaining track numbers.
Changing the track order
You can change your programme before you start
playing.
To You need to
Press CHECK until the track you
Erase a track
don't want appears in the display,
then press CLEAR
Erase the last track in Press CLEAR. Each time you press
the programme the button, the last track will be
cleared.
Add tracks to end of Turn
the programme number you want to add appears,
then press ENTER.
When using the remote, press the
number button of the tracks to be
added.
Change the whole Press p (stop). Create a new
programme completely programme following the
programming procedure.
Playing a CD
AMS ± until track

Recording From CDs

Recording Your Own Programme

You can record the programme you've created on a
tape, DAT or MD. The programme can contain up to 24
tracks.
By inserting a pause during programming, you can
divide the programme into two for recording on both
sides of a tape.
PLAY MODE
·
1
Create your programme (for side A when
recording on a tape) while checking the total
playing time indicated in the display.
Follow Steps 1 to 4 in "Creating a programme on
the player" on page 10 or Steps 1 and 2 in
"Creating a programme using the remote" on
page 10.
A
The indication appears in the display.
2
When you record on both sides of the tape, press
P to insert a pause.
A B
The "P" and indications appear in the display
and the playing time is reset to "0.00."
When you record on one side of the tape or on a
DAT or MD, skip this step and go to Step 4.
A pause is counted as one track
You can programme up to 23 tracks when you insert a
pause.
3
Repeat Step 1 to create the programme for side B.
4
Start recording on the deck and then press · on
the player.
When you record on both sides of the tape, the
player pauses at the end of the programme for side
A.
5
When you record on side B, reverse the tape and
press · or P on the player to resume playing.
To check and change your programme
See the left column of this page.
A
The indication appears while checking the
programme for side A and
programme for side B.
Playing CDs Playing CDs
Playing CDs
ENTER
P
A M S ±
B
while checking the
11 EN