By default the installation creates a MediaLink folder at the following location on
your computer hard drive:
MediaLink
•
MediaLnk52.exe (MLC 52/DVCM 50 Configuration Program)
•
MLC_52_and_DVCM_50_Help.chm (MLC 52 configuration program help file)
Starting the Configuration Program
NOTE:
start the configuration program if you start it in emulation mode.
To run the configuration program:
1.
On your desktop, click
MLC 52
2.
On the Connection Window, select one of the two tabs:
•
Select a Comm Port
computer and the MLC 52. The MLC must be connected to your computer
RS-232 port via either the rear panel 6-pole captive screw control connector or
the front panel 2.5 mm TRS configuration port.
From the
which your MLC is connected to the computer.
Figure 45.
•
Emulation Mode
MLC 52 is attached to the computer.
Figure 46.
C:\Program Files
. The following items are placed in the folder:
It is not necessary to have an MLC 52 connected and powered up in order to
>
Start
Extron Electronics
+
DVCM 50 Control Program
— This tab lets you establish a connection between your
menu, select the PC communications port through
Select a COM Port
Select a Comm Port Tab
— This tab lets you open the software whether or not an
Emulation Mode Tab
MLC 52 MediaLink Controllers • Serial Communication
[
or Program Files (x86)
>
MLC 52
.
]
\Extron\
+
>
DVCM 50
49