Basic Operation - Getting Started - Bush NE-3313 Instruction Manual

Using your DAB/FM Digital Radio
Let's get started

BASIC OPERATION - GETTING STARTED

1. Place the appliance on a flat and stable surface.
2. Connect the mains lead into the socket at the rear of the radio, plug
in and switch on at the mains. The display backlight will illuminate
for a few seconds, a welcome message (fig.1) will appear in the
display briefly and the clock (00:00:00) will flash in the display and
a message 'time is not set' will appear underneath.
3. Fully extend the telescopic antenna.
4. Press the STANDBY / ON (
mode will automatically be selected and the radio will perform a
full autoscan. The display will show 'Scanning' , together with a slide
bar (fig.2) that indicates the progress of the scan and the number of
stations found so far.
5. Once the scan has finished, the radio will select the first
alphanumerically found station.
6. Adjust the volume to the desired level by turning the VOLUME
knob. Turn anticlockwise to reduce the volume and clockwise to
increase the volume.
7. Press the TUNNING (◄) or (►) buttons to scroll through the
located stations. Once the station of choice is located, press the
SELECT button to select the station.
8. Move the antenna or radio until the best reception is received.
9. To switch to FM radio, press the DAB/FM button. Press the button
again to return to DAB.
10. To switch the radio into standby mode, press the STANDBY (
button. The radio will silence, the display will dim but the clock will
still be displayed.
16
) button to turn the unit on, the DAB
Using your DAB/FM Digital Radio
)