Table of Contents
Advertisement
Using your BUSH DAB Mono Radio
Let's get started
Basic operation –getting started
1.Connect the mains adaptor to the DC jack, fully extend the telescopic antenna, plug
in and switch on at the mains and at the ON/OFF switch at the rear of the radio.
2.Slide the ON/OFF switch on rear of units to ON position. The display backlight will
illuminate for a few seconds, a welcome message "Welcome to Digital Radio ' will
appear in the display briefly and the clock (00:00:00) will flash in the display . the DAB
mode will automatically be selected and the first time the radio is connected to the
supply the radio will perform a quick scan The display will show 'Scanning a slide bar
that indicates the progress of the scan, the name of the last station found and the total
number of stations found so far.
3.When the scan is finished the radio will play the first alphanumerically found station.
If the radio does not find any stations, 'No DAB Station' displayed.
4. Adjust the volume to the desired level using the VOL ( + / - ) buttons
5. Press the Previous ( ) or Next ( ) buttons to scroll through the located stations.
Once the station of choice is located , Press the Enter button to select the station .
6. To switch your radio between DAB and FM mode, press Mode (
7. Press and hold the Mode (
'Standby' mode.
8. To completely switch of the radio and the display, slide the switch on the rear of the
radio to 'Off'.
Using the radio - DAB MODE
DAB differs from analogue radio, the separate signals from a number of stations are
grouped together and transmitted as a single frequency. These groups are referred to
as multiplexes and ensembles. Each time a group has been found the name of the
group will be shown on the lower half of the display.
DAB Mode - Auto tune
This function allows the radio to search automatically for DAB, Band III channels.
1.In DAB mode, Press the 'Scan' button to begin a local search for stations. The display
will change to 'Scanning...'A progress bar will show the progress of the scan and the
number of stations found during the scan will also be displayed.
2.When the scan is finished, the radio will return to the station played before the scan
was initiated but any new stations found will have been added.
DAB Mode –Manual tune
This function allows a specific or new ensemble to be manually added to the stations
already available on the radio.
14
) Standby button on the top of the radio will go into
Using your Bush DAB Mono Radio
) button .
Advertisement
Table of Contents
