Table of Contents
Advertisement
Using your DAB/FM Radio
Let's get started
Set the clock in STANDBY mode
1.
Insert the adaptor cord into the power socket at the rear of the radio. Plug the adaptor into the
mains supply socket.
2. The display backlight will illuminate for a few seconds, a welcome message (F1) will appear in
the display briefly and the clock will display "00:00:00 Time is not set".
3. In standby mode, press the ALARM/SNOONZE button, the hour digits will flash in the display,
press ▼/▲ buttons to set the correct hour, then press the SELECT button to confirm.
4. The minute digits will now flash, press ▼/▲ buttons to set the correct minute.
5. Later you will enter to "Set date 1-1-2014". Press ▼/▲ buttons to set date and press SELECT
button to confirm again.
Set the clock in working mode
1.
Connect the radio to AC mains (via AC/DC adaptor), then press
on.
2. Press and hold INFO/MENU button, and then press ▼/▲ buttons until the display show
"System". And press the SELECT button confirm.
3. Continue press ▼/▲ buttons until the display shows "Time" and then press the SELECT button
to confirm. The display will show "<Set Time/Date>", press the SELECT button to confirm again.
4. The hour digits will flash in the display, press ▼/▲ buttons to set the correct hour, and then
press the SELECT button to confirm.
5. The minute digits will now flash, press ▼/▲ buttons to set the correct minute.
6. Later you will enter to "set date 1-1-2014", press ▼/▲ buttons to set date and press SELECT
button to confirm again.
BASIC OPERATION - GETTING STARTED
Press the
STANDY button to turn the unit on, it will automatically enter into the DAB mode and
perform auto scan function. During the scan, the display show "Scanning..." together with a slide
bar
that indicates the progress of the scan and the amount of stations that have been found so far. (F.2)
Once the scan has finished, the radio will select the first alphanumerically found station. You can
now press ▼/▲buttons to explore the found stations followed by pressing the SELECT button to
select listening to the stations.
Note: If there is no stations found after auto scan, the radio will display "Full Scan", you can now
press ▼/▲ buttons to select "Full scan" or "Manual tune" for stations, and press SELECT button to
finally confirm.
F.1
16
STANDBY to turn the radio
F.2
Advertisement
Table of Contents
