Advertisement
CENTERLINE TOWER MAT CONVERSION:
1. Remove the shoulder rest knob and bolt, then push the
shoulder rest toward the carriage and pull up to remove the
shoulder rest. Loosely assemble the knob and bolt on each
shoulder rest and store them under the Reformer.
2. Disconnect all of the Reformer springs from the spring bar
and roll the carriage toward the tower.
3. Rotate the footbar support up to the padded section of the
footbar and then lay the footbar down onto the frame rails. It
should now be inside the frame and lower than the top of the
frame.
4. Inspect the two Tower mats. One of them will have two vinyl
flaps installed on the underside with Velcro for shipping
purposes. Detach, rotate, and re-attach the flaps so they hang
down from the edge of the mat. This is the mat that will go at
the tower end of the Reformer. See figure J. Be sure that the
flaps are aligned with the eye bolts when the mat is installed
so they protect the mat from springs attached to the lowest
eye bolts. The feet on the bottom of the mat fit inside the
Reformer frame to keep it in place, now push it all of the way
toward the tower.
Figure J
5. The other mat is now installed in the same way at the foot
end of the Reformer.
QUESTIONS?
Contact Balanced Body Technical Support at 1-800-PILATES or
+1-916-388-2838.
Balanced Body is not responsible for equipment damage
resulting from incorrect installation.
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | info@pilates.com
400-355 | 01.30.19
Advertisement
