US Robotics Wireless USB Print Server User Manual page 87

Wireless USB Print Server User Guide
be slightly different depending on your version of Windows). Click Print Server
Utility and then Print Driver Setup.
Note: If using the Epson Spooler Manager, this program must be disabled, as
follows:
1. Run the Epson Spooler Manager.
2. Select Queue Setup from the menu.
3. Click Use Print Manager for this port.
4. Click OK to exit.
PTP (Peer-to-Peer) Printer Port Management
Print jobs can be managed like any Windows printer. Open the Printers folder by click
Windows Start, Settings, and then Printers (this may be slightly different
depending on your version of Windows). Double-click any printer to see the current
print jobs.
If the printer attached to the Wireless USB Print Server is changed, run this program
again and select the correct printer.
To delete a port created by this setup program, use the Windows Delete Port option:
1. Right-click any printer in the Printers folder and select Properties.
2. Locate the and click Delete Port. This button is on the Details or Ports tab,
depending on your version of Windows.
If the Wireless USB Print Server's IP Address is changed and you can no longer print,
delete the port (see procedure above) and re-install it.
PTP (Peer-to-Peer) Printer Port Advanced Options
Perform the following steps to access the Peer-to-peer Printing options.
Click Windows Start, Settings, and then Printers (this may be slightly different
depending on your version of Windows) to open the Printers folder. Right-click the
printer and select Properties. The Port Settings button is on the Details or Ports
tab, depending on your version of Windows. Click Port Settings.
An example screen is shown below:
file:///G|/CSO/T-Writer Repository/Networking/5436A Wireless Gutenberg/User Guide/English/printing.html (9 of 14)9/14/2006 4:38:29 PM