Advertisement
•
During this stage, make sure that the start button (8) and speed regulator (9) are easily acces-
sible and that there is sufficient visibility and lighting on the tool, the surrounding area, and the
base.
Notes:
•
It is strictly forbidden to place and/or use the saw when environmental conditions may cause a
fire or an explosion.
•
It is forbidden to use the machine for a purpose other than that intended by the manufacturer.
•
Make sure that operating the saw does not create dangerous situations for persons and/or prop-
erty.
•
If any malfunction is encountered, the machine must be stopped immediately and the reason
and extent of the malfunction be checked. A damaged machine must be repaired before being
taken into operation again. Contact the manufacturer or an authorised service partner if neces-
sary.
Starting
Release the safety switch by turning the (orange) lock down (8), then press the button, and begin cutting
using even pressure.
Caution:
The first time it is started, the machine will be fairly noisy, due to the normal breaking in stage
of the transmission gears. This noise will disappear after approximately 8 working hours. In any case,
the measurable noise level is equal to and not greater than 85 dB (A).
It is absolutely forbidden
•
to lubricate the blade (saw) immediately before/during/after cutting;
•
to work without the blade guide installed and positioned properly;
•
to work without the rear guard;
•
to hold the piece to be cut by hand.
The manufacturer shall not be held liable
of the machine. Failure to observe the safety rules indicated in this manual as well as changes or any
modification to the machine (whether they be slight) will invalidate all warranty.
Maintenance
Replacing the saw
It is essential to wear protective gloves when changing the blade of the tool:
1.
Remove the corner plate (27) from the mobile blade guide.
2. Remove the protective guard (28).
3. Turn the lever (29) towards the position "–".
4. Remove the blade (30).
5. Insert the new blade taking care to observe the cutting direction and placing it between the blade
guide rollers and also between the rubber pulleys (31).
6. Turn the lever (29) towards the position "+".
7. When the lever (29) reaches the end of its stroke, the blade will automatically position itself for
cutting when the motor begins to turn.
8. Replace the guard (28) and plate (27) of the mobile blade guide.
Note:
During the first 4–6 cuts (after replacing the blade), only perform slight cutting pressures to in-
crease the duration and effectiveness of the blade thereafter.
After each working shift
Carefully clean all parts of the machine to remove shavings and cutting residue.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
for damage of any type or nature caused by irrational use
Item 61917
Page 7
11
2021-1
Advertisement
