Advertisement
•
Make sure that it is properly fastened, grasp the centre of the arm (Fig. 2B), and lift it carefully.
Caution:
The machine must only be lifted and carried when it is free of materials or working pieces
always making sure that it has been disconnected from all power sources. In any case, always comply
with current health and safety regulations.
Commissioning
First steps
It is essential to determine size measurements and placement prior to installation in order to ensure safe
placement, running, and possible emergency actions within the surrounding area. These conditions
should be respected beginning with the preliminary stages before cutting begins.
1.
Place the machine on a bench of adequate size and sturdiness (4 threaded holes provided
under the base allow the machine to be fastened securely in place).
2. Move the safety lever (2).
3. Lift the machine using the grip. In this position, it should not come down. If this is not the case,
slightly tighten the screw (17) that works directly on the clutch inside the rotation and lifting unit.
4. Make sure that the machine is aligned with the graded scale (18) according to the chosen cutting
angle.
5. Make sure that the nut (19) is tight.
Note:
Before plugging the machine in, make sure that the line voltage corresponds to the voltage indi-
cated on the machine.
6. Mount the piece holder (20), tightening it by means of the headless screws (21).
7. Loosen the knob (22).
8. Slide the rod (23) to define the desired cutting length.
9. Tighten the knob (22) securely.
10. Set the cutting speed using the regulator (9); set the blade advancement based on the material
to be cut.
Cutting speed
Material
Stainless steel
Copper, aluminium, and their alloys
Steel, etc.
Insert the piece to be cut in the clamp and tighten the clamp lever securely. Only start working when the
working piece cannot move anymore.
Adjusting the blade guide
1.
Loosen the lever (24).
2. Slide the blade guide (25) which also serves as protection until the saw (3) is as much covered
as possible, based on the size of the part to be cut.
Operator position
•
The placement of the machine in relation to the operator position must allow observing the re-
sults of the operation to maintain safety.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Speed (
m
⁄
)
min
20–50
40–60
50–70
Item 61917
Page 6
11
2021-1
Advertisement
