Table of Contents
Advertisement
QUI-1164
3.3
Display screens
There are 5 available screen displays:
[1]
Menu display
The main menu allows the operating
parameters of the pump to be set, by
scrolling to the appropriate menu item.
[2]
Idle display
Shown when the pump is not conducting an
event. Displays flow set point, total sample
volume, run time, the number of events
stored and the percentage of the data log
memory used.
Constant-flow display
[3]
Displays actual flow rate (cc/min),
backpressure BP (inches water, mmHg or
KPa), total sample volume V (Litres), run time
RT (minutes) and projected run time PRT
(hours), based on battery charge status and
backpressure.
[4]
Constant-pressure display
Displays backpressure BP (inches water,
mmHg, KPa), run time RT (minutes) and
projected run time PRT (hours) based on
battery charge status and backpressure.
[5]
Fault display
Displays run time RT (min), fault count FC,
fault run time FT (sec), current fault(s) and
last fault(s) when a fault condition is
detected or when the pump has stopped due
to a fault condition.
www.markes.com
1. Menu Display
2. Idle Display
3. Constant Flow Display
4. Constant Pressure Display
5. Fault Display
Page 11
Advertisement
Table of Contents
