Engine Oil, Change - Volvo Penta D16 Operator's Manual

Maintenance
58

Engine Oil, Change

Always follow the recommended oil change interval.
Use an oil drain pump (optional) to pump the oil out of
the oil pan.
WARNING!
Hot oil and hot surfaces can cause burns.
WARNING!
Working with or approaching a running engine is a
safety risk. Watch out for rotating components and hot
surfaces.
1 Run the engine until warm so that the oil is easier
to pump. Then stop the engine.
2 Connect a suitable hose to the drain pump
discharge (1) and lead it to a collection vessel.
3 Open the tap (2) under the drain pump to the
position for draining engine oil (E).
4 Replace the oil filter and by-pass filter at every oil
change. Refer to the section Oil Filter/By-pass
Filter, Change, page 59.
5 Close the tap (S). Refill with new oil to the correct
level.
IMPORTANT:
Only use oil of recommend quality and viscosity.
Refer to Technical Data, page 79 for oil quantity
and quality and viscosity.
6 Start the engine and let it idle. Check the oil
pressure. Check that no leaks are present at the
filters.
7 Stop the engine. Wait a few minutes before
checking the oil level. Top up as needed.
Hand in the old oil and filters to a recycling station.
47711740 05-2019 © AB VOLVO PENTA