Introduction - Siemens SIMOTICS S-1FT2 Operating Instructions Manual

Introduction

This documentation should be kept in a location where it can be easily accessed and made
available to the personnel responsible.
Target group
These Operating Instructions are intended for installation engineers, commissioning
personnel, machine operators, and service and maintenance personnel.
Utilization phase
Planning and engineering phase, implementation phase, installation and commissioning
phase, application phase, maintenance and service phase.
These operating instructions apply to the SIMOTICS S-1FT2 servo motor, referred to as "1FT2"
in this document.
The Operating Instructions provide information about the components that enable the target
group to install, set up, test, commission, operate, and troubleshoot the products and
systems correctly and safely.
The operating instructions inform you about how to handle the 1FT2 from delivery to final
disposal.
You will find additional information in the configuration manual for the 1FT2.
Before you start using the motor, you must read these Operating Instructions to ensure safe,
problem-free operation and to maximize the service life.
Siemens strives continually to improve the quality of information provided in these Operating
Instructions.
• If you find any mistakes or would like to offer suggestions about how this document could
be improved, contact the Siemens Service Center.
• Always follow the safety instructions and notices in this Product Information.
The warning notice system is explained on the rear of the inside front.
Text features
In addition to the notes that you must observe for your own personal safety as well as to
avoid material damage, in this document you will find the following text features:
Operating instructions
Handling instructions with a specified sequence start with the word "Procedure":
The individual handling steps are numbered.
1. Execute the operating instructions in the specified sequence.
❒
The square indicates the end of the operating instructions.
SIMOTICS S-1FT2 synchronous motors for SINAMICS S120
Operating Instructions, 07/2021, A5E50610821B AB
3