Main Menu Instruction; Chapter 2 Auto Function; Options Instruction Of Auto Interface; Enter Process Interface Of Auto - MicroStep CC-S1 User Manual

北京欣斯达特数字科技有限公司

5. Main menu instruction

Controller version number: current version information
[F2] Auto: automatic cutting program control
[F3] Man: manually adjust torch
[F4] Edit: edit/revise/USB input/output cutting program
[F5] Param (parameter): controller parameters set
[F6] Diagn (Diagnosis): check machine input/output state
[F7] Figur (figure): figures library
[F8] Help: help information of every function
Options instruction of Auto function
[F1] Exit: exit Auto operation
[F2] Man (manual): change to manual operation
[F3] Sectio (section): change to section operation
[F4] BreakP (breakpoint): breakpoint operation
[F5] Figure: figure operation
[F6] Upload: upload program
[F7] Assist: assist operation
[F8] BackRe (back to reference): enter operation of back to reference
2.1 Enter Auto interface
2.1.1 [0] SpeedSet: directly adjust speed parameters of cutting the current program
(IdleSped (speed of idle running (no load), CutSpeed (running speed), ManSpeed (speed of
manual operation), BackSped (speed of backward operation)).
Note:
If current speed settings is not bigger than max. speed (idlespeed) of the parameter
interface, speed settings of parameter interface will not be changed. If bigger than speed
settings of parameter interface and less than max. speed, speed settings of parameter
interface will be change. If bigger than speed settings of parameter interface, then run
based on max. speed.
page: 4

Chapter 2 Auto function

Microstep Website http://www.microstep.cc/eng
Beijing Flourishing Start Digital Technology Co., Ltd