Eyelet Stitching - Brother 885-V35/V37 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/
64 and 3/16 inch).
Stitch Name Pattern
Eyelet stitch
CAUTION
● Be sure to turn off the main power before replacing the presser foot.Otherwise, injuries may
occur if
a Attach monogramming foot "N".
• For details on replacing the presser foot, refer
to "Replacing the presser foot" (page 43).
b Select stitch
• For details, refer to "Selecting stitching"
(page 51).
c Adjust either the stitch width or the stitch
length to select the desired eyelet size.
• For details, refer to "Adjusting the stitch
width" (page 61) and "Adjusting the stitch
length" (page 62).
Application
62
Sewing eyelets, for example, on
belts
(Start/stop button) is accidentally pressed and the machine starts sewing.
62
.
mm 6mm
5mm
Stitch Width
[mm (inch)]
Auto Manual Auto
7.0, 6.0 or
7.0 5.0 7.0
(1/4) (1/4, 15/64 (1/4)
or 3/16)
d Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
e Start sewing.
Once sewing is completed, the sewing
machine automatically sews reinforcement
stitches, then stops.
f Use the eyelet punch to cut a hole in the
center of the eyelet.
When using the eyelet punch, place thick paper
or some other protective sheet under the fabric
before punching the hole in the fabric.
Memo
If thin thread is used, the stitching may be
too open. If this occurs, sew the eyelet twice
before removing the fabric, one on top of the
other.
Stitch Length
Presser
[mm (inch)]
Foot
Manual
7.0, 6.0 or
5.0
N
(1/4, 15/64
or 3/16)

Eyelet Stitching 113

3