Brother 885-V35/V37 Operation Manual page 35

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
f Slide the spool cap onto the spool pin and
return the spool pin to its original position.
Slide the spool cap as far as possible to the right
as shown, with the rounded side on the left.
CAUTION
● If the spool or the spool cap is not
positioned correctly, the thread may
become tangled around the spool pin or
the needle may break.
g Pull the thread from the spool and pass the
thread under the hook of the thread guide.
a Thread guide
h
a
i
Pass the thread behind the thread guide cover
and to the front.
While holding the thread near the spool with
your right hand, pull the thread with your left
hand as shown below.
b
c
a Thread guide cover
b Thread guide spring
c Thread
d When the presser foot lever is lowered
Note
When passing the thread behind the thread
guide cover, be sure to use both hands. If
you do not hold the thread with your right
hand, the thread will be loose and you will
not be able to secure the thread in the thread
spring guide. It may cause incorrect thread
tension.
Make sure that the presser foot lever is raised
before passing the thread behind the thread
guide cover. If the presser foot lever is
lowered, the thread guide spring is shut and
you cannot hang the thread on the thread
guide spring correctly.
Pass the thread through the guides in the order
shown below.
3
1
2
4
Upper Threading 33
a
d
1