Replacing The Needle - Brother 885-V35/V37 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Replacing the needle

Use the screwdriver and a needle that has been
determined to be straight according to the
instructions in "Checking the needle" (page 40).
a Press
twice to raise the needle.
a Needle position button
b Turn off the sewing machine.
CAUTION
Before replacing the needle, be sure to
turn off the sewing machine. Otherwise,
injuries may occur if one of the operation
buttons is accidentally pressed and the
machine starts sewing.
c Place fabric or paper under the presser foot
and cover the holes on the needle plate.
Note
Before replacing the needle, place fabric or
paper under the presser foot to prevent the
needle from falling into the holes in the
needle plate.
(Needle position button) once or
a
d Lower the presser foot lever.
a Presser foot lever
e Hold the needle with your left hand, and then
use a screwdriver to turn the needle clamp
screw toward you (counterclockwise) to
remove the needle.
a Screwdriver
b Needle clamp screw
• Do not apply a strong force when loosening
or tightening the needle clamp screw,
otherwise certain parts of the sewing
machine may be damaged.
f With the flat side of the needle toward the rear
of the machine, insert the needle until it
touches the needle stopper.
a
a Needle stopper
Replacing the Needle 41
a
a
b
1