Eyelet Stitching - Brother SB3150 Operation Manual

Eyelet Stitching

Eyelets, such as those on belts, can be sewn.
• Using the table below, refer to "Using the utility
stitch tables in the "Sewing" section" in the "Basic
operations" section.
Stitch name Stitch
Eyelet stitch
a Attach monogramming foot "N".
b Select stitch .
c Adjust either the stitch width or the stitch length to
select the desired eyelet size.
1
1 7 mm (approx. 1/4 inch)
2 6 mm (approx. 15/64 inch)
3 5 mm (approx. 3/16 inch)
• For details, refer to "Setting the stitch width" and
"Setting the stitch length" in the "Basic operations"
section.
d Lower the needle into the fabric at the beginning of the
stitching, and then lower the presser foot lever.
e Start sewing.
→ Once sewing is completed, the machine
automatically sews reinforcement stitches, then
stops.
Stitch number
4-15 91 71 N
2 3
f Use the eyelet punch to cut a hole in the center of the
eyelet.
• When using the eyelet punch, place thick paper or
some other protective sheet under the fabric before
punching the hole in the fabric.
Memo
• If thin thread is used, the stitching may be too
open. If this occurs, sew the eyelet twice before
removing the fabric, one on top of the other.
Eyelet Stitching
S
Sewing S-37