Page 3
Opening the Magazine, Inserting Staples Inserting Nails, Firing a Round Exhaust Direction, Clearing a Jam Troubleshooting, Cleaning & Maintenance User Notes Warranty...
Page 4
WARNING Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain for future use GENERAL SAFETY INFORMATION. equipment such as a dust mask, non- WARNING! Read all safety warnings skid safety shoes, hard hat, or hearing and all instructions.
Page 5
WARNING Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain for future use until you have read and understand the Maintain the tool. Check for misalignment information in this manual. Learn the or binding of moving parts, breakage of tool’s applications and limitations, as well parts and any other condition that may as the specific potential hazards related...
Page 6
WARNING Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain for future use TRIGGERING DEVICES ladders’ and shall not be used for specific Fastener driving tools are operated application for example: by actuating the trigger using finger when changing one driving location to pressure.
WARNING Please read and understand these Safety Warnings, Safety Symbols and Instructions carefully and retain for future use functioning before putting it down in serious injury to you or others, and will Disconnect an air tool from the air supply invalidate its warranty.
COMPRESSED AIR SYSTEM This 2 in 1 Air Stapler + Nailer is designed to be An in-line filter/lubricator/regulator unit, depicted below, operated at 4.8-7.5bar using clean, dry, regulated, should be installed and should be located as close to the compressed air. Air Nailer+ Stapler, as possible.
SPECIFICATION WORKING RECOMMENDED MAGAZINE PRESSURE PRESSURE LUBRICANT CAPCITY White mineral 4.8-7.5bar 7.5bar A. Nose Cover Release Catch B. Slider C. Magazine D. Tacker Head (Muzzle) E. Soft Grip Handle F. Trigger G. Magazine Release H. Exhaust Direction Dial I. Air Inlet Quick Connector J.
OPENING THE MAGAZINE Always remove the compressor pipe from the Nailer & Stapler before performing adjustments or inserting Nails or Staples. INSERTING STAPLES...
Page 11
INSERTING NAILS Always remove the compressor pipe from the Nailer & Stapler before performing adjustments or inserting Nails or Staples. FIRING A ROUND...
EXHAUST DIRECTION CLEARING A JAM Always remove the compressor pipe from the Nailer & Stapler before performing adjustments or inserting/removing Nails or Staples.
TROUBLESHOOTING PROBLEM CAUSE SOLUTION • O-Ring in trigger valve is • Check and replace O-Ring. damaged. AIR LEAK NEAR BOTTOM OF • Check and replace. • Trigger valve head is damaged. TOOL OR TRIGGER AREA • Check and replace trigger valve Trigger valve stem, seal or O-Ring stem, seal or O-Ring.
5th Floor The Tower Deva City Office Park Manchester M3 7BF Declare under our sole responsibility that the product: SKU: 3500127 Description: VonHaus 2 in 1 Air Stapler + Nailer To which this declaration relates is in conformity with the following directives: 2006/42/EC...
Page 16
Thank you for purchasing the 2 in1 Air Stapler + Nailer VonHaus is a registered trademark of DOMU Brands Ltd Made in China for DOMU Brands Ltd M24 2RW.
Need help?
Do you have a question about the 3500127 and is the answer not in the manual?
Questions and answers