Dimplex FutuRad FutM2CE Manual page 9

Delayed Start Timer Setup
To setup a delayed start timer:
•
First set the Heat mode and Temperature you wish the appliance to operate after the delayed start period.
•
Press and hold the Runback button '
the default delayed start duration of 1Hr (1 hour) will also appear.
•
The Delayed Start duration can be increased using the Runback button '
' ' buttons.
•
To accept and set the Delayed start timer simply allow the setup mode to time-out (approximately 6 seconds
after the last button press).
•
The Delayed start icon will stop flashing and be displayed solid on the screen. The Delayed start duration
count down time will be displayed on the screen.
•
To cancel the Delayed start setup press the standby button while the icon is blinking.
•
The appliance will not emit heat until the countdown clock reaches 00:00, the appliance will automatically switch on
using the settings set before the Delayed start mode was setup.
Cancelling the Delayed Start Timer:
•
To cancel the Delayed Start Timer simply press the Standby button '
•
Press the Standby button again to reactivate the appliance.
Key Lock
To activate the key lock:
•
Press and hold both '
for 2 seconds.
•
The Key Lock icon
•
To unlock the control repeat the action by pressing
both ' ' and ' ' buttons for 2 seconds.
Note: The Standby button will still work when the Key
Lock is active. If the standby button is used again to re
energise the appliance then the last heat settings and
key lock will still be active.
Key Tone Mute
To mute the key tones:
•
Press and hold '
seconds.
•
The 'sound off'
•
To turn on the sound, repeat the action.
' for 2 seconds. The delayed start icon '
Press & Hold
(2 sec.)
Adjust
time
' and ' ' buttons together
will appear on the display.
' and ' ' buttons together for 2
Icon will appear on screen
Allow setup
to time out
(6 sec.)
Adjust
time
' the appliance will enter Standby mode,
Press & hold
' will begin to flash on the screen and
' or alternatively using the ' ' and
Duration Remaining
Until power up
Press & hold