Dimplex FutuRad FutM2CE Manual page 6

Standby & Power Up
When the appliance is plugged in there will be an audible beep and the unit will enter 'Standby' mode. Standby
mode is an inactive mode where the appliance is energised but will not emit any heat. The Standby mode is
identified by a blank display with only the Standby icon illuminated red, as shown below.
First Time Start Up?
YES
On first time start-up the product will start with the
default settings. The temperature will be set to 25
and the heat setting will be set to intelligent (Eco)
heat mode, see Heat Selection.
Screen & Button Sleep Mode
If no buttons have been pressed for approximately 20 seconds, the display screen and buttons will enter sleep
mode, all buttons except the Standby will disappear. Selected screen icons will remain visible to indicate the
active mode but the brightness of the screen icons will dim 50%. To reactivate buttons, place your hand on the
display.
The appliance will continue to function as required once the unit is in sleep mode
Press the
to turn the product
NO
On subsequent start-ups the product will return to
C the last used settings. Heat Selection, Temperature
o
Settings, Temperature units and Sound settings will
return as per the previous operation.
The screen below shows an example where the last
operation settings were with the temperature set to
21 C and Heat Selection to LOW and the sound was
o
turned off.
Standby
button
On
.