Dimplex FutuRad FutM2CE Manual page 8

Manual Mode Setup
Manual mode is the default operational mode. To activate manual mode:
•
From the Standby screen press the standby button ' '. the appliance will automatically enter manual mode
with the default or last used settings.
•
To alter the temperature use the ' ' & ' ' keys as required, the heat mode settings can also be adjusted using
the ' ' key.
Frost protection mode
Within the manual mode the appliance has a frost protection function. This
setting is useful in areas such as garages to assist in the prevention of frost
damage.
To activate this mode, set the temperature to its minimum setting '5°C', the
frost protection symbol (
and OFF to try to maintain a temperature of approximately 5°C and help
protect against frost conditions.
It is normal for the 5°C to be flashing when this model is active, it will stop
flashing once heat is required e.g. if the room temperature drops below 5°C.
Note - This appliance cannot guarantee total frost protection, external factors
such as room size, outside temperature, room insulation properties, etc. will
impact on the reliability of this mode.
Runback Timer Mode Setup
To set Runback Timer:
•
Press the Runback button '
runback duration of 1Hr (1 hour) will also appear.
•
The runback duration can be increased using the Runback button '
buttons.
•
To accept and set the timer simply allow the setup mode to time-out (approximately 6 seconds after the last
button press).
•
The Runback icon will stop flashing and be displayed solid on the screen. The runback duration count down
time will be displayed on the screen.
•
To cancel the Runback mode setup press the standby button while the icon is blinking.
Adjusting or Cancelling the Timer:
•
To adjust the remaining runback time press the Runback button '
process.
•
To cancel the runback Timer press the Runback button '
the Runback time to 0Hr or alternatively press the Standby button while the setup mode is active.
) will illuminate. When set, the heater will cycle ON
'. The Runback icon '
Adjust
time
' will begin to flash on the screen and the default
' or alternatively using the ' ' and ' '
Allow setup
to time out
(6 sec.)
Adjust
time
', the time can then be edited as per the setup
' to enter the setup menu and use the ' ' button to change
Duration Remaining