Table of Contents
Advertisement
4.5 I Storage and wintering
• For wintering, drain off all the water from the cleaner (damage caused by frost is not covered by the warranty).
• Clean the whole device and the hoses in clean water then leave to dry.
• Store them in a dry place protected against frost
• Remove all the connectors and adaptors from the brush socket or the skimmer.
• Remove the hose sections. Check that the hoses are not blocked and store them flat.
Tip: Preserve the condition of the hoses during storage
When the cleaner is stored away, even for short periods, avoid rolling the hoses: they may take on a shape
which may harm the cleaner's performances.
❺ Troubleshooting
• Before you contact your reseller, please carry out these few simple checks using the following
tables if a problem occurs.
• If the problem continues contact your reseller.
5.1 I Device behaviour
• Check that your pool's bottom plug is fully closed.
• Clean and empty the skimmer baskets and the pump's pre-filter.
• Check that the debris does not slow down or stop the motor's operation (see §
I Removing debris from the motor"
• Remove the suction adaptor under the cleaner (see §
The cleaner is
small or large debris (according to model)")
immobile or very
• Check the flow (see §
slow.
• Check that there is no air in the system. If the level of water in the pump's pre-filter
falls or if there are a lot of air bubbles from the discharge nozzles, this means that
there is air in the system. Check the hose conditions and check the filtration pipes.
• Check that the pool coating is not covered with algae which make the surface slippy and
affect the cleaner's traction.
pH.
• Check the flow (see §
Check that the discharge nozzles are pointing downwards.
•
The cleaner
Check that the hose is not folded or rolled up. Leave it to dry flat if necessary.
•
does not move
Check that the hose is long enough (see §
•
everywhere in the
add hose sections.
pool.
Check that the hose floater is correctly positioned (see §
•
Monitor the cleaner for more than five minutes and check that each track changes
•
direction regularly.
Make sure the rotating seal on the top of the cleaner turns freely.
•
The cleaner is
Test the flow by checking the wheel rotation speed (see §
•
stopped on the
rotation speed"
steps.
Check that the hose is not too long (see §
•
shorten it by removing sections.
Check the flow (see §
•
The cleaner does
§
not climb the pool
Check that the hose floater is correctly positioned (see §
•
sides
Check that the sides are not slippy (caused by algae).
•
The cleaner goes
Reduce the flow (see §
•
beyond the water
Check that the hose floater is correctly positioned (see §
•
level.
The cleaner is on
Check that the hose floater is correctly positioned.
•
the side.
H0354600.F - EN - 2015-12
"3.4 I Adjusting the water flow"
If it is, carry out shock chlorination and slightly reduce the
"3.4 I Adjusting the water flow"
).
"3.4 I Adjusting the water flow")
"3.4.2 Adjusting the water flow"
"3.4.2 Adjusting the water flow"
)
"3.5 I Choice of suction mode:
.
).
).
"2.2 I Hose section assembly")
"2.2 I Hose section assembly")
"2.2 I Hose section assembly")
and increase it if necessary (see
).
"2.2 I Hose section assembly")
).
"2.2 I Hose section assembly")
"4.3
. If it is not,
.
"3.4.1 Checking the wheel
. If it is,
.
.
EN
12
Advertisement
Table of Contents
