Adjusting The Rear Puller Device - Siruba NC008 Instruction Book

後滾輪裝置的調整
1. 手動桿 (A) 在下落的狀態，上滾輪與下滾輪
之間的間隙為 0.5mm。將螺絲 (B) 調整到正
確位置後，鎖緊螺帽 (C)。( 圖 41)
2. 後滾輪的壓力調整：
調整螺絲 (D) 順時針旋轉時，壓力增加 ;
逆時針旋轉時，壓力減少。調整完後請鎖緊
螺帽 (E)。( 圖 42)
3. 後滾輪送布量調整：( 圖 42)
調整時，鬆開螺帽 (F)，向上調整送布量變
少，向下調整送布量變多，如果這種調整方
式送布量過大或不夠時，請拆下橡膠塞 (G)，
鬆開螺帽 (H)，向上調整送布量變少，向下
調整送布量變多。
3.Adjusting the feeding amount of the rear
puller : (Fig 42)
To decrease the amount, loosen nut (F) and
move it up. To increase the amount, loosen
nut (F) and move it down.
If the feeding amount is too large or small,
remove the rubber plug (G) and loosen the
nut (H).
To decrease the amount, move it up.
To increase the amount, move it down.
P21
ADJUSTING THE REAR PULLER
DEVICE
圖 40/Fig 40
1.W ith the manual lever(A) lowered, hold
stopper (B) so that the clearance between
the upper and lower pullers is 0.5mm. Then
tighten nut (C). (Fig 41)
2.To adjust the puller pressure :
To increase the pressure, turn adjusting
s c r e w ( D ) c l o c k w i s e . To d e c r e a s e t h e
p r e s s u r e , t u r n a d j u s t i n g s c r e w ( D )
counterclockwise. Fasten the lock nut (E)
after adjusting. (Fig 42)
圖 41/Fig 41
圖 42/Fig 42