Adjusting Stitch Length - Siruba C007L Instruction Book

縫目長度的調節
縫目長度的可調節範圍為 1.4 到 3.6mm。表四
有分別顯示每一英寸 (25.4mm) 與每 30mm 時
可包含的針數。
主 送 布 桿 擋 片 ⑤ 在 產 品 出 廠 時 已 被 螺 絲 ⑥ 固
定，最大只能調節到 3.6mm。( 圖 30)
調節步驟 :( 圖 29)
1. 鬆開固定螺帽①。
2. 將主送布桿④對齊主送布刻度盤③上需求的
位置。轉動調節螺絲②進行調節。
(1) 讓縫目長度變小請順時針旋轉。
(2) 讓縫目長度變大請逆時針旋轉。

ADJUSTING STITCH LENGTH

Stitch length is adjustable from 1.4 to 3.6 mm.
Table 4 shows the number of the stitches per
inch (25.4 mm) and 30 mm converted to the
stitch length.
The main feed lever stopper⑤ has been
adjusted so as to stop at maximum 3.6 mm
with the screw⑥ at shipment.(Fig.30)
Adjusting procedure:(Fig.29)
1.Loosen the lock nut①.
2.Align the end of the main feed lever④ with
表 4/Table 4
圖 29/Fig.29
Introduction
the required position on the main feed
graduations③ . Turn the main feed bar
adjusting screw② to adjust it.
(1)To make the stitch length smaller, turn it
clockwise.
(2)To make the stitch length larger, turn it
counterclockwise.
圖 30/Fig.30
P27