Installation: Side Touch Tap (Sink) - Zenith HydroTap G5 Installation Instructions Manual

2
Side Touch Tap installation
Cap screw
M6 x 35 (supplied)
M6 x 30 (not supplied)
M6 x 40 (not supplied)

Installation: Side Touch Tap (sink)

• Use the template supplied on pages 6-7
Benchtop
thickness
14 - 18 mm
8 - 13 mm
19 - 24 mm
• Use 3x cap screws to suit your benchtop
• Apply a light smearing of silicone sealant
• Pass the tubes and USB cable through
Internal nuts
• From below the bench, feed the three
Tapered base
O-ring seal
• Fit the 3 cap screws and spring washers.
Benchtop
• Use a tube spanner to secure the fixing
Clamp block
Spring washer
Fixing nut
to locate and cut the 35mm hole and 3x
6.5mm clearance holes in the correct
orientation for either left or right hand
operation.
thickness.
on the underside of the O-ring seal to
ensure a watertight fit.
the Ø35mm hole.
tubes and USB cable through the clamp
block, noting the orientation marker.
Tighten with an allen key.
nut.
808081NZ v1.00 03.21 Industrial Tap Instructions 5