Font Installation (Optional) - Zenith HydroTap G5 Installation Instructions Manual

1
Top Touch Tap Font Installation
2
Side Touch Tap Font installation
• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
tap hoses and USB cable.
• Cut the holes as shown in the template.
• Apply a light smearing of silicone sealant
on the underside of the spacer under the
Font. Locate the spacer under the Font
base.
• From below the bench, feed the three
tubes and USB cable through the clamp
block, noting the orientation marker.
• Fit the 3 cap screws and spring
washers. Tighten with an allen key.
• Use a tube spanner to secure the fixing nut.
6 808081NZ v1.00 03.21 Industrial Tap Instructions

Font Installation (optional)

• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
Industrial Top
tap hoses and USB cable.
Touch Tap
• Cut the holes as shown in the template.
Black plastic
• Apply a light smearing of silicone
spacer
sealant on the underside of the spacer
Font
under the Font. Locate the spacer
under the Font base.
Spacer ring
under Font
• Pass the tubes and USB cable through
the hole and use a tube spanner to
secure the tap in place.
Benchtop
Steel washer
Spider clamp
Fixing nut
Industrial Side
Touch Tap -
Tapered base
O-ring seal
Font
Spacer ring
under font
Benchtop
Clamp block
Spring washer
Fixing nut
Cap screws x3