Before Installation - Zenith HydroTap G5 Installation Instructions Manual

Tools needed for tap installation
In addition to normal tools, the following (or equivalent) will be required.
35mm diameter sheet metal hole punch for sinks.
•
35mm diameter hole saw for worktops.
•
Hole saw for font installation (optional - refer to font kit)
•
Tube spanner for fixing the tap assembly (supplied).
•
Water supply pressure requirements
BC Compact
Positioning
Position the tap such that it dispenses into
the sink bowl with clearance for a cup or tea
pot.
Alternatively, refer to pages 8-9 for tap
installation on a Font.
Position Command Centre and Tap as close
together as possible.

Before Installation

Be aware of the risks of hazards which could
!
cause harm when using tools. Assess the
risks before starting the installation.
Min - Max pressure, kPA (bar)
HydroTap
Booster
Ensure that taps are positioned to minimise
!
the risks of scalding when dispensing
boiling water.
170 (1.7) - 700 (7.0)
200 (2.0) - 700 (7.0)
808081NZ v1.00 03.21 Industrial Tap Instructions 3