Self-Testing Procedure - NEC QB-MINI2 User Manual

7.2 Self-Testing Procedure

(1) Preparation and installation of software
The following software is required to perform self-testing.
software, refer to the setup manual supplied with MINICUBE2.
• MINICUBE2 diagnostic tool
• USB driver
(2) Switch setting
The mode select switch can be set to "M1" or "M2".
Set the power select switch to "3" or "5".
(3) Connecting the USB cable
Connect MINICUBE2 to the host machine. Do not connect MINICUBE2 to the target system. The mode
LED glows white after connection.
MINICUBE2 MINICUBE2
(4) Startup of MINICUBE2 diagnostic tool
Start the MINICUBE2 diagnostic tool.
If the MINICUBE2 diagnostic tool was installed when NEC Electronics software was installed, the diagnostic
tool is registered on the Start menu as follows.
"NEC Electronics"→"MINICUBE Utilities"→"Vx.xx (version)"
•
For the operation after this step, refer to the user's manual for the MINICUBE2 diagnostic tool.
166
CHAPTER 7
Figure 7-2. Connecting MINICUBE2 to Host Machine
USB cable USB cable
User's Manual U18371EJ1V0UM
SELF-TESTING
For details on preparation and installation of
Host machine Host machine