Table of Contents
Advertisement
CHAPTER 3
This chapter describes how to use MINICUBE2 when performing on-chip debugging and flash programming for
a V850 microcontroller.
On-chip debugging is a method to debug a microcontroller mounted on the target system, using a debug
function implemented in the device. Since debugging is performed with the target device operating on the board,
this method is suitable for field debugging.
Flash programming is a method to write a program to the flash memory embedded in a device. Erasing,
writing and verifying the program can be performed on-board with the device.
Read the following chapters if you are using MINICUBE2 for the first time with a V850 microcontroller as the
target device.
• 3.1
Target System Design
For communication between MINICUBE2 and the target system, communication circuits must be mounted on
the target system. This section describes the circuit design and mounting of connectors.
• 3.2 On-Chip Debugging
This section describes the system configuration and startup method to perform on-chip debugging with
MINICUBE2.
• 3.3 Flash Programming
This section describes the system configuration and startup method to perform flash programming with
MINICUBE2.
HOW TO USE MINICUBE2 WITH V850 MICROCONTROLLER
User's Manual U18371EJ1V0UM
17
Advertisement
Table of Contents
