Troubleshooting; Please Do Not Return This Product To The Store - Bissell MOMENTUM 82G7 SERIES User Manual

T
roubleshooting
Vacuum cleaner won't run
Possible causes
1. Vacuum cleaner is not plugged in
2. Blown fuse/tripped breaker
Vacuum cleaner or tools won't pick up dirt
Possible causes
1. Incorrect height adjustment
2. Hose not attached to suction opening
3. Twist 'n Snap hose not securely attached
4 Crack or hole in hose
5. Broken or worn drive belt
6. Rotating floor brush bristles worn
7. Rotating floor brush jammed
8. Clog in vacuum
9. Dirt container full
10. Dirt container or upper tank not installed properly
11. Filters are dirty
12. TurboBrush is clogged or debris is wrapped
around the brush roll
Vacuum cleaner is difficult to push
Possible causes
1. Incorrect height adjustment
Visible dirt escaping from cleaner
Possible causes
1. Dirt container full
2. Filters missing or installed incorrectly
3. Dirt container installed incorrectly
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

For any questions or concerns, BISSELL is happy to be of service.
w w w . b i s s e l l . c o m
Contact us directly at 1-800-237-7691.
WARNING:
To reduce the risk of electric shock, turn power OFF
and disconnect plug from electrical outlet before
performing maintenance or troubleshooting.
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker
Remedies
1. Adjust powerfoot to correct height
2. Firmly push hose wand into the suction opening
3. Make sure Twist 'n Snap hose is snapped into locked position
4. Check hose and replace if needed
5. Replace drive belt, see page 13
6. Replace brush
7. Remove brush and clean debris from brush ends
8. Clear clog, see page 15
9. Empty dirt container
10. Position correctly and lock in place
11. Check and clean upper tank, pre-motor and post-motor filters
12. Maintaining TurboBrush, see page 14
Remedies
1. Adjust powerfoot to correct height setting
Remedies
1. Empty dirt container
2. Check upper tank, pre-motor and post-motor filters for
correct installation
3. Pull out and re-insert dirt container correctly
8 0 0 . 2 3 7 . 7 6 9 1
17