Check Rotating Floor Brush And Drive Belt - Bissell MOMENTUM 82G7 SERIES User Manual

M
aintenance and care

Check rotating floor brush and drive belt

You should check your vacuum clean-
er's rotating floor brush and drive belt
regularly for wear or damage. You
should also clean the brush and brush
ends of strings, hair and carpet fibers.
This type of debris can wrap around
the brush and hamper its ability to
effectively clean your carpet. Also
remove any debris that has
accumulated under the brush cover.
1. Unplug the vacuum from electrical outlet.
2. Place handle in low position and turn the
vacuum cleaner over so bottom side is
facing up.
3. Lift tab 1 and release the three latches
in order 2-4 as marked. Lift off the brush
cover.
4. Grasp the rotating floor brush at both
ends and lift.
5. Clean strings, hair and other debris
from the rotating floor brush, paying
particular attention to brush ends.
6. Clean strings, hair and other debris from
the motor pulley and drive belt areas.
7. Check the drive belt carefully for wear,
cuts or stressed areas.
8. Check air passageway for obstructions.
Remove debris from this area.
9. Insert front edge of brush cover, rotate
into place, and snap three latches.
12
w w w . b i s s e l l . c o m
WARNING:
To reduce the risk of injury from
moving parts, turn vacuum cleaner
off and disconnect power plug from
electrical outlet.
3.
4.
Motor
Pulley
Air Passageway
8 0 0 . 2 3 7 . 7 6 9 1