Check Rotating Floor Brush And Drive Belt - Bissell POWER GROOM COMPACT PET 13H8 User Manual

M
aintenance and Care

Check rotating floor brush and drive belt

You should check your vacuum cleaner's
rotating floor brush and drive belt
regularly for wear or damage. You should
also free the brush and brush ends of
strings, hair and carpet fibers. This type
of debris can wrap around the brush and
hamper its ability to effectively clean your
carpet. Also remove any debris that has
accumulated under the brush cover.
1.
Unplug the vacuum from electrical outlet.
2.
Place handle in low position and turn
vacuum cleaner over so bottom side is
facing up.
3.
Remove the five screws in the brush
cover. Lift off the brush cover.
4.
Grasp rotating floor brush at both ends
and lift.
5.
Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6.
Clean strings, hair and other debris from
motor pulley and drive belt areas.
7.
Check drive belt carefully for wear, cuts,
or stressed areas.
8.
Check air passageway for obstructions.
Remove debris from this area.
9.
When finished cleaning, reposition floor
brush and drive belt. Rotate the belt
by hand towards the motor pulley to
seat the belt properly on the brush roll.
Replace the brush cover and secure with
all five screws.
10
WARNING:
To reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect Power Plug from
electrical outlet.
3
4