Replace Drive Belt - Bissell POWER GROOM COMPACT PET 13H8 User Manual

M
aintenance and Care

Replace drive belt

1.
Unplug the vacuum from electrical outlet.
2.
With rotating floor brush removed from
vacuum cleaner (refer to steps 1-4 of check
rotating brush and belt drive on page
10), grasp old drive belt and remove from
motor pulley. Discard the old drive belt.
3.
Place new drive belt over motor pulley
and loop other end over rotating floor
brush in the space between the bristles.
NOTE: It is important that you
use only genuine BISSELL replace-
ment belts. Aftermarket belts may
not meet the exact specifications
required to keep your vacuum
operating at its peak performance.
The use of unbranded belts could
lead to early failure of the vacuum
and void your warranty.
4.
Pull the rotating floor brush into position
and place ends of brush into the slots as
shown. Alignment of brush ends in slots
is necessary to fully insert the brush.
Drive belt will be under tension when
installed properly.
5.
Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center
itself on rotating brush crown.
6.
Replace brush cover and all five screws.
2
Motor
Pulley
3
4
11