Summary of Contents for Bissell CLEANVIEW REWIND PET 1820 Series
Page 1
CLEANVIEW REWIND PET ® Vacuum __________ USER GUIDE 1820 SERIES More of a video person? Look for this icon and go online for an instructional how-to video at www.BISSELL.ca...
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way. www.BISSELL.ca...
Thanks for buying a BISSELL vacuum! We love to clean and we’re excited to share one of our innovative products with you. This guide has important instructions on how your new vacuum works, including using (page 6), maintaining (pages 7-9), and if there is a problem, troubleshooting (page 10).
Button Stretch Tank Hose Release Button Suction Carry Handle Indicator Pre-Motor Filter Extension (not shown) Wand Clip Dirt Tank Extension Wand Cord Rewind Post-Motor Filter Recline Height Pedal Adjustment NOTE: The Crevice Tool is stored inside the Extension Wand. www.BISSELL.ca...
Page 5
Wrap hose up and around the hose wrap on the handle. Slide end of hose into vacuum base. NOTE: The powerfoot will not suction properly unless the hose is fi rmly attached. www.BISSELL.ca...
Page 6
Do not place vacuum close enough to objects to pull them into rotating brush. NOTE: Certain carpets and low humidity conditions may generate small static discharges. Static discharges are entirely harmless and are not associated in any way with the main power supply. www.BISSELL.ca...
Page 7
Press press firmly until in and turn clockwise you hear “click”. to lock. NOTE: The dirt tank may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing. www.BISSELL.ca...
Page 8
Firmly pull filter tray out. NOTE: The pleated post-motor filter may NOT be washed with water or detergent. Replace the post-motor filter every 3 to 6 months. www.BISSELL.ca...
Page 9
Inspect until slot appears, Place brush roll with belt back in. for damages and then separate Faceplate will not close properly if all replace if necessary. faceplate. parts are not aligned correctly. www.BISSELL.ca...
Adjust powerfoot to correct difficult to push height setting, see page 6 Dirt tank full Empty dirt tank Visible dirt escaping from Filters missing or installed Check pre-motor and post-motor vacuum incorrectly filters for correct installation, see page 8 www.BISSELL.ca...
Service If your BISSELL product should require service: Contact BISSELL Consumer Care to locate a BISSELL Authorized Service Center in your area. If you need information about repairs or replacement parts, or if you have questions about your warranty, contact BISSELL Consumer Care.