Assembly; Attach Handle To Vacuum; Attach Vacuum Hose And Tools - Bissell POWER GROOM COMPACT PET 13H8 User Manual

A
ssembly
The only tool you'll need to
assemble your vacuum cleaner is a
Phillips screwdriver.

Attach handle to vacuum

1.
Locate the vacuum handle and
remove the screw packet taped
to the handle.
2.
Stand the vacuum upright. From
the rear of the unit slide the base
of the handle into the grooves at
the top of the vacuum body.
3.
Ensure the handle fits to the
vacuum body. If there are any
gaps, continue to push firmly
until the handle is fully seated.
4.
Insert the screw into the existing
hole. Tighten with a screwdriver
until secure.

Attach vacuum hose and tools

1.
Slide the end of the hose into the
hose wand base. Snap the hose into
the hose holder.
Note: The vacuum will not
operate properly unless the
hose wand is firmly attached.
2.
Place the crevice tool on the stor-
age post on the left side of the tank
(when viewing vacuum from rear).
3.
Place the Pet TurboBrush tool on the
storage post located near the back
of the upper handle.
4.
Place the dusting brush on the
storage post located on the lower
cord wrap.
5.
Wrap power cord around
cord wraps.
2
4
1
3
5
2
4
5